2008 Arctic Cat 700 Diesel ATV Service Manual, Page 41Get this manual
13Assemble the rocker arm assembly installing the rocker arms and supports in the original positions as removed coating all components with clean engine oilHold components in place with rubber bands DE541
NOTE: If the rocker arm assembly is to be disassembled, label all rocker arms for installing purposesIf the rocker arms are mixed up, the complete overhead must be adjustedDE529
9After labeling rocker arms and supports, remove components from the rocker arm shaft10Inspect the wear points on the rocker arm shaft and using micrometer, measure the shaftThe measurements must be within specifications
Installing
NOTE: The flywheel end of the camshaft includes bolt-on eccentric to drive the lift pumpIf the eccentric has been removed, install and tighten the cap screw to 58 ft-lb