2008 Arctic Cat 700 Diesel ATV Service Manual, Page 36Get this manual
7Using new O-ring, coat the flange of the camshaft bearing retainer and the camshaft support bearing with clean engine oil and install into the cylinder headSecure with the three cap screws and tighten to ft-lb
10Install the timing belt (see Left-Side Components in this section)11Install the valve cover using new gasket; then secure with the ten cap screws and using crisscross pattern, tighten to 6.5 ft-lb
8Being careful not to damage the oil seal, lightly coat the camshaft drive pulley flange with clean engine oil and install on the camshaftNOTE: The camshaft drive pulley has molded extrusion in the pulley bore that must engage the keyway in the camshaft