2008 Arctic Cat 700 Diesel ATV Service Manual, Page 19Get this manual
4Carefully check the entire hydraulic brake system that all hose connections are tight, the bleed screws are tight, the protective caps are installed, and no leakage is present ! CAUTION
This hydraulic brake system is designed to use DOT brake fluid onlyIf brake fluid must be added, care must be taken as brake fluid is very corrosive to painted surfaces
INSPECTING HOSES Carefully inspect the hydraulic brake hoses for cracks or other damageIf found, the brake hoses must be replacedCHECKINGREPLACING PADS The clearance between the brake pads and brake discs is adjusted automatically as the brake pads wearThe only maintenance that is required is replacement of the brake pads when they show excessive wearCheck the thickness of each of the brake pads as follows1Remove front wheel2Measure the thickness of each brake pad3If thickness of either brake pad is less than 1.0 mm (0.039 in, the brake pads must be replacedPR377B PR237
CInstall the new brake padsDSecure the caliper to the knuckle andor axle housing with the cap screwsTighten to 20 ft-lb