2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 418Get this manual
Seat REMOVINGINSTALLING 1To remove the seat, lift up on the latch release (located at the rear of the seat)Raise the rear of the seat and slide it rearward2To lock the seat into position, slide the front of the seat into the seat retainers and push down firmly on the rear of seatThe seat should automatically lock into positionREMOVINGINSTALLING (TRV) 1To remove the rear seat, pull the two latch handles to the rear and rotate them to the vertical position
5Secure the front and rear panels with two machine screws; then install the left and right side panelsNOTE: If the front body panel has not been installed, see Front Body PanelSide Panels in this section
6Place the seat into position making sure it locks securely
Taillight Assembly
REMOVING 1Unplug the three-prong connector and free the taillight wiring harness from the frame2Remove the torx-head cap screws securing the taillight assembly to the frameAccount for any washers3Remove the taillight assemblyINSPECTING