2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 417Get this manual
INSTALLING MUFFLER 1Place the muffler into position engaging the mounting lugs into the grommets; then slide the muffler forward2Install the two exhaust springs NOTE: If the front body panel has not been removed, the left-side and right-side panels and the two machine screws must be removed (see Front Body PanelSide Panels in this section)
CLEANING AND INSPECTING
NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
Rear Body PanelRack
REMOVING 1Remove the cap screws and lock nuts securing the rear rack; then remove the rear rackAccount for the bushings2Remove one shoulder screw and lock nut and three plastic rivets (on each side) securing the rear body panel to the footwells
1Clean all rear body panel components with warm soap and water2Inspect side panels and rear body panel for cracks and loose rivets3Inspect threaded areas of all mounting bosses for stripping4Inspect for missing decalsINSTALLING 1Remove the gas tank cap and set the rear body panel in position; then install the cap and connect the taillightbrakelight connector2Place the rear rack in position with the bushings and secure with the cap screws and lock nutsTighten securely3Install one shoulder screw and three plastic rivets (on each side) to secure the front of the rear body panel to the footwellsCD691A