2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 410Get this manual
CLEANING AND INSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
1Clean all bumper components with parts-cleaning solvent2Inspect all welds for cracking or bendingINSTALLING 1Place the front bumper assembly into position and install the through-boltStart the lock nut and finger-tighten only2Install the two flange bolts and lock nuts on the upper supportsTighten all hardware securelyCF143A
4Disconnect the four headlight connectors and the taillightbrakelight connector from the sockets
FrontRear Body Panel
REMOVING 1Remove the seat; then remove the battery covertool tray2Remove the negative battery cable from the battery; then remove the positive cableRemove the vent hose; then remove the batteryCF135A