2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 406Get this manual
Handlebar Grip REMOVING 1Remove the plug and end-cap from the handlebar2Using compressed air between the grip and the handlebar, twist the grip back and forth until it slides free of the handlebarINSPECTING
NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
7Remove the two cap screws securing the ball joints in the knuckle8Tap the ball joint end out of the knuckle; then remove the knuckle9Remove the snap ring from the knuckle; then remove the bearing
1Inspect the grip for wear, cuts, or cracks2Inspect the grip for deteriorationINSTALLING
NOTE: Before installing grip, use contact spray or alcohol to clean the inside of the grip and the handlebar of glue residue, oil, or any other contaminantPR287A
1Apply liberal amount of Handlebar Grip Adhesive to the inside of the grip2Slide the grip onto the handlebar until it is fully seated with the smooth part of the grip facing up3Wipe off any excess glue; then secure the grip with the handlebar plug and end-capPR288