2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 364Get this manual
OUTPUT VOLTAGE NOTE: Needle adapters will be required on the multimeter leads as the following tests are made with the sensor connected
1Connect the three-wire plug to the sensor; then remove the right-side mounting screw securing the sensor to the rear frame
NOTE: When replacing the sensor after testing, make sure the arrow marking is directed up
2Install the needle adapters to the multimeter leads; then select DC Voltage on the multimeter3Connect the red tester lead to the bluebrown wire (B) and the black tester lead to the blackyellow wire (A); then turn the ignition switch ON and observe the meterThe meter should read 0.8-3.0 DC volts