2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 329Get this manual
11Use tape to cover and seal the intake opening ! CAUTION
Any objects or liquid entering the intake opening will fall into the engine causing severe damage if the engine is turned over or started
INSTALLING 1Install the throttle body into the intake pipe and secure with the clampTighten securelyFI092A
6Remove the screw securing the throttle actuator cover to the throttle body; then remove the cover7Remove the throttle cable from the actuator arm8Loosen the outer jam nut securing the throttle cable to the throttle body; then route the cable out of the way9Remove the four electrical connectors from the throttle body components
2Place new O-ring in the intake pipe; then position the pipe onto the engine and secure with two cap screws3Connect the throttle cable to the throttle body and adjust throttle free-play (see Section 2); then connect the gasline hose4Connect the four electrical connectors to the throttle body components5Install the air filter housing boot and secure with the clamp; then install the air filter, air filter cover, storage compartment, and storage compartment cover6Install the seat making sure it locks securely in place