2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 307Get this manual
12Spread the faces of the driven pulley by pushing the inner face toward the engine while turning it counterclockwise; then when the faces are separated, press the V-belt down between the pulley faces13Place the V-belt into position over the front shaft FI428A
15Rotate the V-belt and drivedriven assemblies until the V-belt is flush with the top of the driven pulley16Install the V-belt housing assembly and tighten the three cap screws securelyFI221
NOTE: The arrows on the V-belt should point forward
14Pinch the V-belt together near its center and slide the movable drive face and clutch housing spacer onto the shaftSecure the drive face with cap screw (threads coated with red Loctite #271)Tighten the cap screw to 81 ft-lb