2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 298Get this manual
14Verify that the washers are properly located; then install the magneto cover and secure with the cap screwsTighten only until snug FI148
15Tighten the cap screws (from step 14) to ft-lb16Place the speed sensor housing and new O-ring into position and secure with the cap screwTighten securely17Place the water pump into position and secure with three cap screwsTighten securelyFI301
13Install the two alignment pins (A) in the crankcase; then place the gasket in position