2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 286Get this manual
Inspecting Cam Chain Guide 1Inspect cam chain guide for cuts, tears, breaks, or chips2If the chain guide is damaged, it must be replacedHoning Cylinder 1Using slide gauge and dial indicator or snap gauge, measure the cylinder bore diameter in three locations from top to bottom and again from top to bottom at 90 from the first measurements for total of six measurementsThe trueness (out-of-roundness) is the difference between the highest and lowest readingMaximum trueness (out-of-roundness) must not exceed specifications
2Rotate the camshaft and note runout; maximum tolerance must not exceed specificationsMeasuring Camshaft Lobe Height 1Using calipers, measure each cam lobe height
ATV1013A