2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 276Get this manual
21On the left side, disconnect the gear shift position switch (A), stator connector (B), and the crankshaft position sensor connector (C)
23Loosen the clamp securing the throttle body to the intake pipe; then remove the throttle body and secure it out of the way24Remove the two cap screws securing the intake pipe to the cylinder head and remove the intake pipeAccount for an O-ring
! CAUTION
Cover the intake opening to prevent hardware or dirt from entering the intake or severe engine damage could occur
25Remove the engine damper stopper from the frame; then remove the engine damper mount and damper from the engineFI083A
22Using an absorbent towel to catch any spilled gas, press the locking tab release on the gasline hose connector; then slide the gasline hose connector off the fuel rail