2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 255Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 255


5Remove the three remaining forks noting their positions for assembling purposes
10Remove the crank balancer assembly (A)
AT THIS POINT
To service gear shift forks, see Servicing Center Crankcase Components sub-section
6Remove the reverse idle gear (K) wshaftAccount for the bushing, two washers, and the snap ring7Simultaneously, remove the driveshaft assembly (I) and countershaft assembly (D)Account for the washer on the countershaft
AT THIS POINT
To service the driveshaft andor countershaft, see Servicing Center Crankcase Components sub-section

NOTE: There is flat spot on the crank balancer to allow clearance past the crankshaft

Back to 2008 Arctic Cat 400/500/650/700 ATV Service Manual