2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 241Get this manual
26Install the inside snap ring onto the hilow range shift shaft with the sharp side of the snap ring facing the engine; then place the shift lever assembly part way onto the shaftNOTE: Position the shift lever part way onto the splines and verify the subtransmission is in hi rangeIf not, shift into hi range
Right-Side Components
NOTE: For efficiency, it is preferable to remove and disassemble only those components which need to be addressed and to service only those componentsThe technician should use discretion and sound judgment
AT THIS POINT
To service any one specific component, only limited disassembly of components may be necessaryNote the AT THIS POINT information in each sub-section