2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 182Get this manual
Assembling 1If removed, insert the spiral spring into the case with the outer end of the spring around the mounting lug in the case; then wind it in counterclockwise direction until the complete spring is installedNOTE: The spiral spring must seat evenly in the recoil case B601D
9With the 50 cm (20 in of rope exposed, hook the rope in the notch of the reel10Rotate the reel four turns counterclockwise; then release the rope from the notch and allow the rope to retract11Pull the rope out two or three times to check for correct tensionB606D
2Insert the rope through the hole in the reel and tie knot in the end; then wrap the rope counter- clockwise around the reel leaving approximately 50 cm (20 in of rope free of the reel3Apply low-temperature grease to the spring and hub4Thread the end of the rope through the guide hole of the case; then thread the rope through the handle and secure it with double knotInstall the protective cover into the handle5Align the inner hook of the spiral spring with the notch in the reel