2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 144Get this manual
Separating Crankcase Halves 1Remove the left-side and right-side cap screws securing the crankcase halves noting the position of the different-sized cap screws for joining purposesMD1033
NOTE: At this point, the wedge can be removed from between the driven pulley faces
19Rotate the V-belt and drivedriven assemblies until the V-belt is flush with the top of the driven pulley20Install two alignment pins and place new V-belt cover gasket into position on the clutch coverInstall the V-belt cover noting the position of the long cap screws and rubber washer and two wire formsIn crisscross pattern, tighten cap screws to ft-lb
MD1012 MD1306