2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 132Get this manual
11Tighten the cap screws (from step 9) in crisscross pattern securely12Place the gasket, recoil starter assembly, and cover into position on the left-side cover making sure the single washer is properly positioned; then install and tighten the four cap screws to ft-lb Right-Side Components
AT THIS POINT
To service center crankcase components only, proceed to Removing Right-Side ComponentsMD1306
NOTE: For efficiency, it is preferable to remove and disassemble only those components which need to be addressed and to service only those componentsThe technician should use discretion and sound judgment
AT THIS POINT
To service any one specific component, only limited disassembly of components may be necessaryNote the AT THIS POINT information in each sub-sectionMD1307