2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 131Get this manual
4Install the shift detent cam making sure the spacer is properly positioned
8Place the key into its notch; then slide the rotor flywheel (with the ring gear in place) over the crankshaftTighten the nut to 116 ft-lbCCover DRecoil Starter
NOTE: Steps 1-8 in the preceding sub-section must precede this procedure
9Install two alignment pins and place the left-side cover gasket into positionInstall the left-side coverNoting the different-lengthed mm cap screws, the position of the shifter bracket, and the location of the long cap screw with the washer, tighten cap screws only until snugMD1086