2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 85Get this manual
NOTE: After placing the primary clutch assembly onto the shaft, pull out on the pressure plate tower to ensure the pressure plate has engaged the clutch hub properly and make sure the plates (drive and driven) are brought together tightly prior to tightening the nut securing the clutch assembly 12Using clutch sleeve hub holder, install the nut and washerTighten to 72 ft-lbNOTE: The washer is directionalCare must be taken to install it correctlyCD440
15Install the release roller assembly making sure the four springs are in position; then using crisscross pattern, tighten the four cap screws securelyNOTE: Tighten the four roller assembly cap screws in crisscross pattern making sure there is no clearance between the clutch plates when secured