2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 52Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 52

CCylinder DPiston NOTE: Steps 1-11 in the preceding sub-section must precede this procedure
12Remove the two nuts securing the right side of the cylinder to the right-side crankcase halfAccount for the washers

15Using the Piston Pin Puller, remove the piston pinAccount for the opposite-side circlipRemove the pistonNOTE: It is advisable to remove the opposite-side circlip prior to using the puller
MD1226A

13Lift the cylinder off the crankcase taking care not to allow the piston to drop against the crankcaseAccount for the gasket and two alignment pins

NOTE: Support the connecting rod with rubber bands to avoid damaging the rod or install the Connecting Rod Holder
! CAUTION

Back to 2008 Arctic Cat 400/500/650/700 ATV Service Manual