2008 Arctic Cat 366 ATV Service Manual, Page 132Get this manual
3Using sharp utility knife, split the handlebar grip from end to end and peel off the rubber4Using an adhesive solvent, clean all glue residue from the handlebarINSTALLING 1Apply liberal amount of Handlebar Grip Adhesive to the inside of the new grip2Slide the grip onto the handlebar until it is fully seated with the smooth part of the grip facing up3Wipe off any excess glue; then secure the grip with the plug, end cap, and cap screwPR288
! CAUTION
Use extreme care when removing the bearingIf the bearing is allowed to fall, it will be damaged and will have to be replaced