2008 Arctic Cat 366 ATV Service Manual, Page 126Get this manual
6Secure the brake caliper to the knuckle with the two cap screws (right side only)Tighten the caliper to 20 ft-lb7Compress the hand brake lever and engage the brake lever lock; then secure the hub nut (from step 5) to the drive axleTighten to 200 ft-lb8Install new cotter pin and spread the pin to secure the nut9Secure the shock absorber to the frame with cap screw and new lock nutTighten to 35 ft-lbKC0100
7Slide the hub out of the knuckle and set aside8Remove the cap screws and lock nuts securing the knuckle to the A-armsDiscard the lock nutsNOTE: Never reuse lock nutOnce lock nut has been removed, it must be replaced with new lock nut
10Secure the shock absorber to the lower A-arm with cap screw and new lock nutTighten to 20 ft-lb11Secure the boot guard to the lower A-arm with the two cap screwsTighten securely12Install the wheel and tighten to 40 ft-lb13Remove the ATV from the support stand
9Remove the cap screws and lock nuts securing the A-arms to the frame; then remove the A-armsNOTE: If removing the upper right A-arm, it will be necessary to disconnect the brake hose from the A-arm