2008 Arctic Cat 366 ATV Service Manual, Page 114Get this manual
Drive Axles REMOVING REAR DRIVE AXLES 1Secure the ATV on support stand to elevate the wheels
! WARNING
Make sure the ATV is solidly supported on the support stand to avoid injury
2Pump up the hand brake; then engage the brake lever lock3Remove the rear wheels4Remove the cotter pin securing the hex nut; then remove the hex nutRelease the brake lever lock5Remove the brake caliper (right side only)NOTE: Do not allow the brake caliper to hang from the hoseAF897D
4Install the brake calipers and secure with the patch-lock cap screws tightened to 20 ft-lb
! CAUTION