2008 Arctic Cat 366 ATV Service Manual, Page 107Get this manual
1Remove the cap screws securing the pinion housingAccount for the coupler, fork, and spring KX222
4Install the input shaft into the housing; then install the front boot and secure with an appropriate boot clamp and the rear boot with an appropriate boot clamp
2Remove the cap screws securing the gear case coverAccount for and make note of the ID tag location for assembling purposes
5Using new O-ring lubricated with grease, install the front drive actuator and secure with the cap screws6Place the pinion housing with new gasket onto the gear case housing; then secure with the existing cap screwsTighten to 23 ft-lbNOTE: If new gear case housing is being installed, tighten the cap screws to 28 ft-lb