2008 Arctic Cat 366 ATV Service Manual, Page 98Get this manual
1Set the meter selector to the DC Voltage position2Connect the black tester lead to the black wire; then connect the red tester lead to the brownblue wire3The meter must show battery voltageNOTE: If the meter does not show voltage, inspect fuses, wiring harness, connectors, and switches Back-Up Lights
The back-up lights connectors are located on the rear frame supports attached by metal tabThey may be released from the frame by depressing the release with small screwdriver
VOLTAGE (Brakelights)
NOTE: Perform this test on the main harness side of the connectorAlso, the ignition switch should be in the ON position and the brake (either foot pedal or hand lever) must be applied
1Set the meter selector to the DC Voltage position2Connect the black tester lead to the black wire; then connect the red tester lead to the greenyellow wire3The meter must show battery voltageNOTE: If the meter does not show voltage, inspect bulb, fuses, wiring harness, connectors, and switchesKC279