2008 Arctic Cat 366 ATV Service Manual, Page 96Get this manual
NOTE: Make sure that the ignition switch is in the ON position, transmission in neutral, brake lock released, and the emergency stop switch in the RUN position NOTE: If the meter showed no voltage, inspect ground connections, starter motor lead, battery voltage (at the battery), starter relay, or the neutral start relay
3Depress the starter button while observing the multimeterThe multimeter should drop to volts, "click" should be heard from the relay, and the starter motor should runNOTE: If "click" is heard and any voltage is indicated by the multimeter, replace the starter relayIf no "click" is heard and the multimeter continues to indicate battery voltage, test the neutral start relay
REMOVING 1Disconnect the battery
! CAUTION
Always disconnect the negative battery cable from the battery first; then disconnect the positive cable
2Remove the nut securing the positive cable to the starter; then remove the cable from the starter3Remove the two cap screws securing the starter to the crankcase; then remove the starterAccount for an O-ringINSTALLING 1Apply small amount of grease to the O-ring seal on the starter; then install the starter into the crankcaseSecure with two cap screws making sure the engine ground is secured by the rear cap screwsTighten to ft-lb