2008 Arctic Cat 366 ATV Service Manual, Page 71Get this manual
Joining Crankcase Halves 1Verify that the two alignment pins are in place and that both case halves are clean and grease freeApply Three Bond Sealant to the mating surfacesPlace the right-side half onto the left-side halfCC871
5In crisscrosscase-to-case pattern, tighten the mm cap screws until the halves are correctly joined; then tighten to 21 ft-lbNOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs
6In crisscrosscase-to-case pattern, tighten the mm cap screws to 10 ft-lbMD1336
2Using plastic mallet, lightly tap the case halves together until cap screws can be installed3From the right side, install the crankcase cap screws noting the location of the different-sized cap screws; then tighten only until snugNOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs while tightening the cap screws