2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 141Get this manual
2Place bushings and sleeves (where appropriate) into shock eyelet; then install shock with two cap screws and nutsTighten all nuts to specifications ! CAUTION
Do not tighten the nuts beyond the 4.8 kg-m (35 ft-lb) specification or the shock eyelet or mount WILL be damaged
NOTE: The rear shock absorber-to-lower A-arm torque factor is 2.8 kg-m (20 ft-lb)
3Remove the vehicle from the support stand
5Remove the hub assembly6Remove the cotter pin and slotted nut securing the tie rod end to the knuckle; then remove the tie rod end from the knuckle7Remove the cap screws securing the ball joints to the knuckle