2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 95Get this manual
Fan REMOVING
1Remove the radiator (see RadiatorOil Cooler in this section)2Remove the fan assembly from the radiatorINSTALLING
1Position the fan assembly on the radiator; then secure with existing hardwareNOTE: The fan wiring must be in the upper-right position
5Remove the two cap screws securing the water pump to the engine; then remove the water pump
2Install the radiator (see RadiatorOil Cooler in this section)
Water Pump
NOTE: The water pump is not serviceable componentIf the pump is defective or if the mechanical seal is leaking (coolant dripping from the discharge hole), the water pump must be replaced