2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 67Get this manual
15Spread the faces of the driven pulley by pushing the inner face toward the engine while turning it counterclockwise; then when the faces are separated, insert wedge (approximately 38 inthick) between the facesRelease the inner face16Place the V-belt into position on the driven pulley and over the front shaft 19Place the V-belt cover gasket into position; then install the cover and secure with the cap screws making sure the different-lengthed cap screws are in their proper locationTighten the cap screws to specifications
NOTE: The arrows on the V-belt should point forward
Installing Right-Side Components
NOTE: Plug the oil passage in the crankcase housing prior to installing the drive geardriven gear assembly to prevent loss of an alignment pin