2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 63Get this manual
11Install the front and rear secondary driven shaft assemblies into the left side of the crankcase making sure the bearing locating pins are facing upward and the bearing C-ring is fully seated in the crankcase CC674
8Place washer on each end of the gear shift shaft; then install the shaft assembly making sure the two holes on the end of the shaft are positioned vertically9Insert the two shift forks into the sliding dogs noting the direction of the tabs from disassembling; then install the shift fork shaftNOTE: Make sure the shift fork tabs face upward and that they are properly seated into the shift camsCD268A
12Place the oil strainer into position; then secure with the two screws13Place the oil strainer cap into position making sure the O-ring is in position; then secure the cap with cap screwsTighten securely