2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 55Get this manual
6Using spanner and suitable breaker bar, loosen the notched-ring nut; then spin the nut free of the hub CD067
4Using suitable marking pen, make alignment marks on the fixed face spring holder and both pulley faces
7Firmly hold the handle and slowly turn the wing nut counterclockwise to relax the springNOTE: There will be tendency for the handle to rotate clockwise approximately turn as the spring holder clears the flats or hubThis is due to slight counterclockwise preload on the spring
5Place the holding handle on the spring holder fitting the two dowel pins into the spring holder face; then install flat washer and the wing nutTurn the wing nut down until resistance is feltNOTE: Do not use the wing nut to compress the spring further