2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 93Get this manual
8Connect the red MaxiClip to the blue wire; then connect voltmeter to the MaxiClips (red meter lead to red and black meter lead to black)9Set the meter selector to the DC Voltage position; then turn the ignition switch to the LIGHTS position and the light control switch to the HI beam positionThe tester must indicate battery voltage and the high beam indicator light (15) must illuminateIf the tester does not read battery voltage, troubleshoot the ignition switch, light control switch, or wiring harness and connectors10Connect the red MaxiClip to the brownblack wireThe tester must read battery voltage and the speedometer backlight (5) must illuminateIf the tester does not read battery voltage, troubleshoot the ignition switch or wiring harness connectors11Depress and hold the ModeSet button (1)The speedometer should switch between mph and kmh as indicated by icon (12)12Depress and hold the ModeSet button (2)The distance mode should shift between ODO and TRIP as indicated by icon (12)13Depress and hold the ModeSet buttons (1) and (2) simultaneouslyThe hour segment of the clock should flash indicating the clock (13) is in the set modeRelease the ModeSet button (2) and release when the desired hour (1-24) appears14Depress and release the ModeSet button (1) to shift the clock set to the minute segment; then depress ModeSet button (2) to set the desired minuteNOTE: In the clock set mode, the gauge will default to normal operation 10 seconds after the ModeSet buttons are released Ignition Switch