2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 74Get this manual
15Install the carburetor (see Section 4)16Install the exhaust pipemuffler assembly (see Section 17Install the gas tank (see Section 4)18Install the air filter housing (see Section 8)19Install the body (see Section 8)20Install the gas tank cover panelKM344
9Install the output drive sprocket cover with the existing hardware and tighten securely10Connect the upper and lower coolant hoses to the engine and secure with the clampsTighten securely11Connect the front and rear cooling boots to the V-belt housing and secure with the clampsTighten securely12Connect the starter wire to the starter stud and secure with washer and nutTighten securely13Connect the stator connector, shift position connector, and the coolant temperature sensor; then secure the engine ground cable to the engine and tighten the cap screw securely