2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 71Get this manual

2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 71

ATV-1085B

NOTE: Note the direction of the exhaust side of the piston (5) for correct ring end gap orientation
BInstall the compression rings (1 and 2) so the letter on the top surface of each ring faces the dome of the pistonRotate the rings until the ring end gaps are on directly opposite sides of the piston according to the illustration

7Install the alignment pins and new gasket on the crankcase; then install the V-belt cover and secure with the cap screwsDRecoil Starter (Utility Model)
NOTE: Steps 1-7 in the preceding sub-section must precede this procedure
8Install the recoil starter and secure with the cap screwsTighten securely

Back to 2007 Arctic Cat DVX/Utility 250 ATV Service Manual