2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 69Get this manual
BRotorFlywheel CTrigger Coil DStator Coil
4Install the starter idler shaft and gear in the crankcase; then install the starter driven gear oil on the crankshaft
5In crisscrosscase-to-case pattern, tighten the cap screws until the halves are correctly joined; then tighten to specificationsNOTE: Rotate the crankshaft back and forth to ensure no binding or sticking occurs
AT THIS POINT
After completing center crankcase components, proceed to Installing Right-Side Components, to Installing Left-Side Components, and to Installing Top-Side Components
NOTE: Make sure the crankshaft and rotorflywheel contact surfaces are clean and dry before installing the flywheel
Installing Right-Side Components
AOil Pump