2007 Arctic Cat ATVs factory service and repair manual, Page 412Get this manual
DISASSEMBLING AXLES
1Using side-cutters (or suitable substitute), remove the large clamp from the boot
5Inspect the splines of the shaft, the bearing ring, and the housing for damageCD020
2Wipe away excess grease to access the retaining ringUsing an awl or circlip pliers, remove the circlip
1 NOTE: If any damage apparent to the splines, the bearing ring, andor the housing, the drive axle must be replaced as an assembly
6Using side-cutters (or suitable substitute), remove the small clamp from the shaft