2007 Arctic Cat ATVs factory service and repair manual, Page 392Get this manual
4Remove the red tester lead from spade terminal and connect it to spade terminal BThe meter should read 4.5-5.5 DC voltsH NOTE: If the meter does not read as specified, check for poor connections at the ECU or openlbroken wires in the wiring harness H NOTE: If any meter reading is not as specified, replace or adjust the TPS (see INSTALLINGIADJUSTING in this sub-section)
7Connect the positive lead to the battery; then connect the negative lead
- make sure the ignition switch is in the OFF Always
position before disconnecting the ECU
8Connect the main harness TPS connector to the TPS; then using Maxiclips (pln 0744-041), connect the black tester lead to the greenlblack wire
5Turn the ignition switch to the OFF position; then disconnect the battery (negative cable first)
Always disconnect the battery when performing resistance tests to avoid damaging the multimeter
6Select the OHMS position on the meter; then perform the following resistance tests on the TPS