2007 Arctic Cat ATVs factory service and repair manual, Page 386Get this manual
7Apply small amount of grease to the front cover bearing and seal; then install the seal protector
10Apply small amount of grease to the O-ring seal on the starter; then install the starter into the crankcaseSecure with two cap screws and wiring forms11Secure the positive cable to the starter with the nut12Connect the batteryTESTING VOLTAGE
Perform this test on the starter motor positive terminalTo access the terminal, slide the boot awayNOTE: The ignition switch must be in the ON position, the emergency stop switch in the RUN position, the reverse lever (on manual transmission models) in the FORWARD position, and the shift lever (on automatic transmission models) in the NEUTRAL position