2007 Arctic Cat ATVs factory service and repair manual, Page 373Get this manual
Fan Motor The connector is the black two-prong one located behind the fan assembly1 NOTE: The ignition switch must be in the ON position
1 NOTE: If the meter shows more than ohm of resistance, troubleshoot or replace the switchcomponent, the connector, or the switch wiring harness1 NOTE: To determine if the fan motor is good, connect the blue wire from the fan connector to 12 volt DC power supply; then connect the black wire from the fan connector to groundThe fan should operate
VOLTAGE (Main Harness Connector to Fan Motor)
A CAUTION
Care should be taken to keep clear of the fan blades
Set the meter selector to the DC Voltage positionConnect the red tester lead to the blacklred wire (5001650 HI1700 EFI) or the blacklorange wire (400); then connect the black tester lead to groundThe meter must show battery voltage1 NOTE: If the meter shows no battery voltage,
Fuse BlockPower Distribution Module
The fuses are located in power distribution module under the seatIf there is any type of electrical system failure, always check the fuses first1 NOTE: The ignition switch must be in the LIGHTS position