2007 Arctic Cat ATVs factory service and repair manual, Page 333Get this manual
10Install the reverse idler gear assembly noting the positioning of the two washers, gear, bushing, and shaft Joining Crankcase Halves
1Apply High-Temp Sealant to the left-side mating surface2Lightly oil all bearings and grease all shafts in the right-side crankcase
3Making sure to align the shafts and alignment pins, join the two crankcase halves
the rear secondary driven shaft assemblyinto the left side of the crankcase making sure the bearing locating pin (1) is facing upward and the bearing C-rinc (2) is fully seated in the crankcase
Do not heat the bearing in the right-side crankcase seal will OccurDamage to the
4Usin plastic mallet, lightly tap the case halves toget er until cap screws can be installed
5From the right side, install the mm cap screws (two inside the case); then tighten only until snugI NOTE: Rotate the shafts back and forth to ensure no binding or sticking occursI
6From the right side, install the rnm cap screws (two inside the case); then tighten only until snugl NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs