2007 Arctic Cat ATVs factory service and repair manual, Page 296Get this manual
Make sure the ignition switch is in the OFF position and the FUEL fuse is removed from the PDM to prevent inadvertent discharge of gas from the gasline hose 21On the left side, disconnect the gear position indicator connector (A), stator connector (B), and the crankshaft position sensor connector (C)
23Loosen the clamp securing the throttle body to the intake pipe; then remove the throttle body and secure it out of the way
24Remove the two cap screws securing the intake pipe to the cylinder head and remove the intake pipeAccount for an O-ring
22Using an absorbent towel to catch any spilled as, press the locking tab release on the gasline nose connector; then slide the gasline hose connector off the fuel rail
Cover the intake opening to prevent hardware or dirt from entering the intake or severe engine damage could occur