2007 Arctic Cat ATVs factory service and repair manual, Page 156Get this manual
Making sure the eight movable drive face rollers are in position, pinch the V-belt together near its center and slide the spacer and movable drive face onto the shaftCoat the threads of the nut with red Loctite #271 and secure the movable drive faceTighten the nut to specifications Installing Left-Side Components
AStarter Idler Gears BRotorIFlywheel
1Place the crankshaft bearing retainer into positionApply red Loctite #271 to the three Phillips-head screwsInstall and tighten the three Phillips-head screws securely
2Install the starter motor and tighten the two cap screws securely3Install the driveshaft spacer making sure the stepped side is to the inside1 NOTE: At this point, the wedge can be removed from between the driven pulley faces