2007 Arctic Cat ATVs factory service and repair manual, Page 102Get this manual
13Install the two alignment pins into the left
crankcase half
l NOTE: Make sure that three washers and two alignment pins are in place
16Place the gear shift stopper wlspring and washer into position above the hillow shift shaft making sure the spring and stopper are correctly positionedTighten to specifications
CCover DSpeedometer Drive EHiILow Shifter Assembly FRecoil Starter
Steps 1-13 in the preceding sub-section must precede this procedurei NOTE:
17Place the speed sensor into position and secure with the two cap screwsTighten securely