2007 Arctic Cat ATVs factory service and repair manual, Page 96Get this manual
I NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs A CAUTION
3Place the oil pump into position in the crankcase and secure with the three Phillips-head screws coated with blue Loctite #243Tighten to specifications
After completing center crankcase components, proceed to Installing Right-Side Components, to Installing Left-Side Components, and to In- stalling Top-Side Components
Installing Right-Side Components
Oil Strainerfoil Pump Gear Shift Shaft
Place the oil strainer with new O-ring into position beneath the crankcase and tighten securely with the Phillips-head cap screws
4Place the washer and pin into position on the oil pump shaft, install the oil pump driven gear, and secure with the circlipI NOTE: Always use new circlip when installing the driven gear