2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 451Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 451

INSTALLING
1Position the brake housing on the handlebarSecure with clamp screws; then tighten securely
Throttle Control
REMOVING

1Remove the two machine screws securing the throttle control to the handlebar2Slide the grommet out of the lower half of the throttle control; then remove the cable from the actuator arm

2Using two new crush washers, connect the banjo-fitting to the master cylinder; then secure with the banjo-fitting bolt

Back to 2007 Arctic Cat ATVs 400/500/650/700 Service Manual