2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 411Get this manual
Drive Axles REMOVING REAR DRIVE AXLE
8While holding the drive axle stationary, pull the top of the knuckle out and down until it is free of the drive axle9Place drain pan under the ATV to contain any oil leakage; then using slide hammer, remove the drive axle
1Secure the ATV on support stand to elevate the wheels
! WARNING
Make sure the ATV is solidly supported on the support stand to avoid injury
2Pump up the hand brake; then engage the brake lever lock3Remove the wheel4Remove the cotter pin securing the hex nut; then remove the hex nutRelease the brake lever lockAF935
REMOVING FRONT DRIVE AXLE
NOTE: For removing front drive axle, see Front Differential in this section
CLEANING AND INSPECTING