2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 374Get this manual
Fuses ! CAUTION
Always disconnect the battery when performing resistance tests to avoid damaging the multimeter
1Set the meter selector to the OHMS position2Connect the red tester lead to one spade end of the fuse; then connect the black tester lead to the other spade end3The meter must show less than ohm resistanceIf the meter reads open, replace the fuseNOTE: Make sure the fuses are returned to their proper position according to amperageRefer to the fuse block cover for fuse placementCF202A
Ignition Coil
The ignition coil is on the frame above the engineTo access the coil, the side panel (see Section 2) must be removedRESISTANCE