2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 242Get this manual
AT THIS POINT To service gear shift forks, see Servicing Center Crankcase Components sub-section
6Remove the reverse idle gear (K) wshaftAccount for the bushing, two washers, and the circlip7Simultaneously, remove the driveshaft assembly (I) and countershaft assembly (D)Account for the washer on the countershaft
AT THIS POINT
To service the driveshaft andor countershaft, see Servicing Center Crankcase Components sub-section
10Remove the crank balancer assembly (A)
NOTE: For efficiency, if the driveshaft andor countershaft are not being serviced, it is preferable to leave them assembledThe technician should use discretion and sound judgment
8Remove the front output shaft (J) and rear shaft assembliesAccount for the bearing C-ringNOTE: Note the alignment marks on the crank balancer driven gear and balancer drive gear to aid in assemblyCD832B